Othar Max 75.7 S.G.

General information: OTHAR MAX 75.7 S.G. is a broad spectrum systemic herbicide. It is not selective except for those crops genetically modified to be tolerant to glyphosate. It is specially recommended to be used before sowing. It has no residual effect.

Chemical group: derived from glicine

Download Label >    |    Download Datasheet >   |   Download Transport Sheet >

Category:

Othar Max 75.7 S.G.

Active principle:

OtharMax-Tabla1

 

 

Formulation: Soluble granules

Dose:

OtharMax-Tabla2

 

 

 

 

 

 

 

 

Mixing method: Pour clean water, pH around 3.5 to 6.5, in the application tank up to one half of its capacity. Then add OTHAR MAX 75.7 S.G. following the recommended dose and application rate of the equipment. Complete with water. It is advised to use it with CLE adjuvant to improve the quality of the water. Keep the stirring device operating during the whole process. Repeat the operation if it rains in a 6 hour period after the application. 

Application method: Calculate the volume to be applied per hectare. Calibrate the equipment in order to have a correct application. 25 to 30 drops per cm2 should be achieved. Don’t use more than 100 liters of mixing solution per hectare.  Avoid diminishing speed, double applications or any other maneuver that could end up in excessive product application.

Compatibility: Its use in mixtures with hormonal herbicides, fenoxiderivates, nor with any product formulated as a concentrated suspension or a wettable powder is not advised.

Preventing resistance generation: it is recommended crop rotation or using OTHAR MAX 75.7 S.G. combined with other herbicides with different modes of action in order to minimize the appearance of tolerant biotypes of different weeds.

Re-entry time: not less than 24 hours.